
A burst pipe can release a huge amount of water very quickly. What you do in the first few minutes makes a big difference to the damage – here's exactly what to do.
1. Turn off the water
Find your stopcock – usually under the kitchen sink, sometimes in a hall cupboard or where the mains enters the house – and turn it clockwise until it stops. If you have a cold water tank in the attic, the gate valve on the pipe leaving it will stop that supply too.
2. Switch off the boiler and immersion
Heating appliances shouldn't run with no water feeding them. Turn off the boiler and immersion at the switch.
3. Keep away from electrics
If water is near sockets, lights or the fuse board, turn off the electricity at the mains if it's safe to reach. Never touch electrics with wet hands or while standing in water.
4. Drain the system
Open cold taps (and flush toilets) to empty water from the pipes so less escapes from the burst. Catch drips with buckets and towels, and move valuables away.
5. Take photos and call a plumber
Photograph the damage for your insurer, then call a qualified plumber. A proper repair replaces the damaged section and checks nearby joints so it doesn't happen again.
Preventing it next time
Insulate pipes in attics, garages and outside walls, fix dripping taps, and keep a little heat on during freezing spells – especially if you're away.






